Genie Screw Drive User Manual

Contents

Genie Screw Drive User Manual Manual pdf 14 page image

14MAIN ASSEMBLY FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM14. Attach emergency release knob, cordand tag.• Tie an overhand knot in one end ofemergency release cord [17].– Slide cord through center of knob [18] .Fig. 1-17.– Slide cord through hole in emergencyrelease lever (on carriage).– Tie a second knot in this end. Fig. 1-18.– Slip wire of emergency release tag [19]through hole in emergency release leverand twist it around itself.15. Attach limit switches.• “CLOSE” limit switch [15B].(Switches are identical.)– Place “CLOSE” limit switch over top of railabout 12 inches from rail strap. Fig. 1-19.– Check that white lever is towardpower head.– Insert set screw [16] into limit switchhand tight only to temporarily hold switchin place. Fig. 1-19A.– Attach brown wire to switch. Fig. 1-19B.– Leaving some slack in wire (Fig. 1-20),run wire down inside groove in top of railback to power head.– Use wire clip [44] to help maintain slack.Fig. 1-20.• “OPEN” limit switch [15A].– Place “OPEN” limit switch over top of railabout 12 inches from power head. Fig. 1-21.– Check that white lever is on side away frompower head. (This means limit switcheshang off opposite sides of rail. Check thisto help verify they are installed properly.)– Insert set screw [16] into limit switch handtight only to temporarily hold switch in place.– Attach grey wire to switch. Fig. 1-21.– Leaving some slack in wire (Fig. 1-21),run wire down inside groove in top of railback to power head.– Use wire clip [44] to help maintain slack.Fig. 1-21.• Coil excess wire and tape it to top of powerhead. Fig. 1-21A.Fig. 1-19ABFig. 1-20wire clippower headFig. 1-21A“close”switch“open”switchset screwOPEN GREEN PARTS BAGScrews for attaching light cover are included in this bag.Please set aside for use later.grey wirebrown wireFig. 1-17Fig. 1-18releaseknobtagcord#8-32 x 3/8" Hex head screw Wire clip[16] [44]