Genie Screw Drive User Manual
                                   | |
Contents
| 
28SETTINGS (CONTACT REVERSE) FOR HELP-1.800.354.3643 OR GENIECOMPANY.COMFig. 7-3Limit switch adjustments must be completedbefore running contact reverse test.1. Test contact reverse.• Open door using wall control.• Lay 2" x 4" board * on floor in center of garagedoor opening. Fig. 7-3.• Close door using wall control.– Door should stop and reversewithin 2 seconds of contacting the board.– If door does not reverse properly:a. Decrease closing force a small amountby turning the “CLOSE” force adjustmentscrew slightly counterclockwise.b. Test contact reverse again.c. Repeat steps a. and b. until contactreverse works properly.*If you don’t have a 2" x 4" board handy, any object1-1/2 inches high that can withstand being hit by thegarage door without sustaining damage is fine.NOTE: If door is stopping but not reversing,“CLOSE” limit switch must be moved closer todoor.SECT 8—BATTERY & VISOR CLIP FOR HELP-1.800.354.3643 OR GENIECOMPANY.COMVisor ClipBatteryBatteryCover1. Install / replace battery Fig. 8-1.• Using a pen or similar object, gently push inon tab.• Cover snaps open. Remove old battery.• Observe polarity markings (+,-) insidebattery compartment.• Match new battery to polarity markings andinstal new A23, 12 Volt battery.• Replace battery cover.NOTE: Use only A23, 12 Volt battery.2. Attach visor clip Fig. 6-1.• Slide clip in slot on back of remote control.– Snap in place.ModelNumberFig. 8-1 |
Related manuals for Genie CM7600 Series
manualsdatabase
Your AI-powered manual search engine