Genie WHDSDI16 User Manual

Contents

Genie WHDSDI16 User Manual Manual pdf 38 page image

DVR User Manual32normal schedule setup; you can refer to 4.4.1 Schedule for details.This step is very important for alarm out. Even if you have enabled alarm out in themotion based alarm or sensor based alarm, you will not see the result ofalarm out if no schedule is added here.BuzzerIt is an inbuilt alarm output device. To setup Buzzer:Step1: Enter into MenuSetupAlarm out Buzzer tab;Step2: Checkmark Buzzer and set buzzer alarm hold time. This would trigger the buzzerwhen the system is in alarm. Fig 4-26 Alarm Out4.6 Network ConfigurationNetwork configuration includes five submenus: network, sub stream, Email, server and other settings. Network settings must beconfigured if DVR is used for monitoring over network.4.6.1 NetworkStep 1: Enter into MenuSetupNetworknetwork tab. Refer to Fig4-27:Step 2: HTTP port: the default value is 80. If the value changed, you need to modify the IPaddress in the IE address .i.e. if HTTP port is 82 and IP address is, 192.168.0.25, you shallinput http://192.168.0.25:82 in IE browser.Server port: Communication port.Step 3: Connect internet. If you have a DHCP server running and would like your DVR toautomatically obtain an IP address and other network settings from that server, check thecheckbox beside "Obtain an IP address automatically". Then the device will distribute IPaddress, subnet mask, and gateway IP and DNS server. If you want to configure your ownsettings, please input the IP address, Subnet mask, Gateway DNS server manually. You canalso check the PPOE checkbox to enable this feature and then enter username and Fig 4-27 Network