Installation ManualH3C S5600 Series Ethernet Switches Chapter 3 Installing the Switch3-103.3 Installing/Removing the Power ModuleCaution:To avoid bodily injury, do not touch any bare conducting wire, screw, and the part whichis labeled danger voltage.3.3.1 Installing the Power ModuleThe power module of the S5600 series is swappable. Follow those steps to install thepower module:Step 1: Wear an ESD wrist strip, and make sure it is well grounded.Step 2: Verify that the power module is not installed upside-down (the module should beinstalled according to the letters. If the module is installed upside down, it will fail to befully seated due to the specially designed inside structure of the chassis). Use onehand to hold the handle on the front, and another to hold the bottom. Slide it gentlyalong the power slot. Push the module until it is fully seated.Step 3: Use a Phillips screwdriver to fasten the captive screws at both sides of themodule.3.3.2 Removing the Power ModuleThe power module of S5600 series Ethernet switch is swappable. Follow those steps toremove the power module:Step 1: Wear an ESD wrist strip, and make sure it is well grounded.Step 2: Disconnect all power of the switch.Step 3: Use a Phillips screwdriver to unscrew the captive screws at both sides of themoduleStep 4: Use one hand to hold the handle on the front, and another to hold the top. Pullout the module stably towards you along the power slot until it is completely apart fromthe chassis bottom.