Installation ManualH3C S5600 Series Ethernet Switches Chapter 5 Loading Boot ROM and Host Software5-7Note:You do not need to reset the HyperTerminal’s baud rate and can skip the last step if youhave chosen 9600 bps. In this case, the system does not display the above promptmessage but “BootROM is updating now.....................................done!” instead.Step 11: Reset HyperTerminal’s baud rate to 9600bps with reference to Steps 5 and 6described above. Then, press any key as prompted. The system will display thefollowing information when it completes the loading.Bootrom updating.....................................done!III. Loading host softwareFollow these steps to download host software of the switch:Step 1: Select <1> in the Boot Menu. The system displays the following information:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3Select <3>. The subsequent steps are the same as those for loading Boot ROM, exceptfor the program to be downloaded in prompt messages.5.2.3 Loading Software from an Ethernet Port Using TFTPI. Introduction to TFTPTrivial File Transfer Protocol is a TCP/IP protocol used for file transfer between clientsand servers. It uses UDP to provide unreliable data stream transfer service.II. Loading Boot ROMStep 1: Select an Ethernet port on the switch for loading and connect it to the PC wherethe file to be downloaded is stored. (You must know PC’s IP address). Besides, connectthe console port on the switch to an external PC. This PC can be the same one thatstores the file to be downloaded.Step 2: Run the TFTP Server program on the PC connected to the Ethernet port, andspecify the path for program loading.