H3C S12500-X Series Installation Manual

Also see for S12500-X: Card Manual Manual Command reference Configuration guide Configuration Examples

104• CXP modules listed in Table 42.• CXP fiber cables listed in Table 43.• CFP2 modules listed in Table 44.Table 35 SFP+ module specificationsModel Centralwavelength Connector CablespecificationsModebandwidthMaximumtransmissiondistanceSFP-XG-SX-MM850-A 850 nm LC50/125 μmmulti-modeoptical fiber2000 MHz*km 300 m (984.25 ft)500 MHz*km 82 m (269.03 ft)400 MHz*km 66 m (216.54 ft)62.5/125 μmmulti-modeoptical fiber200 MHz*km 33 m (108.27 ft)160 MHz*km 26 m (85.3 ft)SFP-XG-LX-SM1310 1310 nm LC9/125 μmsingle-modeoptical fiberN/A 10 km (6.21miles)SFP-XG-LH40-SM1550 1550 nm LC9/125 μmsingle-modeoptical fiberN/A 40 km (24.86miles)SFP-XG-LH80-SM1550 1550 nm LC9/125 μmsingle-modeoptical fiberN/A 80 km (49.71miles)SFP-XG-LH80-Tunable1528.773 to1566.723nmLC9/125 μmsingle-modeoptical fiberN/A 80 km (49.71miles)IMPORTANT:• Only the LSX1TGS48FC1, LSXM1TGS48FE1, LSXM1TGS48FX1, LSXM2TGS48FX1, andLSXM1TGS24FX1 LPUs support the SFP-XG-LH80-Tunable module.• The SFP-XG-LH80-Tunable module is supported only in Release 1150 and later.• Ports 45 to 48 on the LSX1GP48EB1 LPU support all SFP+ modules except the SFP-XG-LH80-SM1550and SFP-XG-LH80-Tunable.NOTE:• The SFP-XG-LH80-Tunable module supports wavelength adjustment. You can use the itu-channelcommand in Ethernet interface view to adjust the wavelength of the module. To display ITU channelinformation for transceiver modules, execute the display transceiver itu-channel command.• Cold-staring the SFP-XG-LH80-Tunable module takes a longer time (usually not exceeding 90s) thancold-starting any other SFP+ modules.Table 36 SFP+ copper cable specificationsModel Cable length DescriptionLSWM2STK 1.2 m (3.94 ft)Used for connecting SFP+ portsLSWM3STK 3 m (9.84 ft)