H3C S12500-X Series Installation Manual

Also see for S12500-X: Card Manual Manual Command reference Configuration guide Configuration Examples

59# Enable the Telnet server.[Sysname] telnet server enable# Enter the view of user line VTY 0.[Sysname] user-interface vty 0# Enable password authentication on the user line.[Sysname-line-vty0] authentication-mode password# Set the password to hello in plaintext.[Sysname-line-vty0] set authentication password simple hello# Assign user role network-admin through the user line VTY 0.[Sysname-line-vty0] user-role network-admin[Sysname-line-vty0] quitConfiguring the basic network settings• Configure IP addresses# Create VLAN-interface 1.[Sysname] interface vlan-interface 1# Assign an IP address, for example, 192.168.0.1, to VLAN-interface 1.[Sysname-Vlan-interface1] ip address 192.168.0.1 24[Sysname-Vlan-interface1] quit• Configure static routes# Configure a static route, with the destination IP address 172.16.1.0 and the next hop IP address192.168.0.2.[Sysname] ip route-static 172.16.1.0 255.255.255.0 192.168.0.2• Configure VLANs# Create VLAN 10 and enter its view.[Sysname] vlan 10[Sysname-vlan10]# Assign port Ten-GigabitEthernet 1/0/1 to VLAN 10.[Sysname-vlan10] port ten-gigabitethernet 1/0/1[Sysname-vlan10] quit• Configure MSTP# Create an MST region named example, map VLAN 10 to instance 1, and set the MSTP revisionlevel to 0.[Sysname] stp region-configuration[Sysname-mst-region] region-name example[Sysname-mst-region] instance 1 vlan 10[Sysname-mst-region] revision-level 0# Activate the MST region configuration.[Sysname-mst-region] active region-configuration[Sysname-mst-region] quit# Configure the switch as the primary root bridge of instance 1.[Sysname] stp instance 1 root primary# Enable MSTP globally.[Sysname] stp global enable