H3C S12500-X Series Installation Manual

Also see for S12500-X: Card Manual Manual Command reference Configuration guide Configuration Examples

1524. Put the packed plastic panel and air filter into their boxes, respectively, and tape the flaps of theboxes with packing tape.Repackaging the power moduleCAUTION:Before removing a power module, switch off the circuit breakers at the input end of all power cords,and remove all the power cords to avoid device damage and bodily injury.To repackage a power module:1. Prepare the packing bag and box of the power module. Make sure the bag is clean, dry, and notdamaged.2. Remove all power modules from the chassis.For information about how to remove a power module, see "Replacement procedures."3. Put the removed power module into the bag.4. Put the packed power module into the box, and tape the flaps of the box with packing tape.Repackaging the card1. Prepare the anti-static bag and box of the card. Make sure the bag is clean, dry, and notdamaged.2. Remove the transceiver modules from the card.If no transceiver module is installed on the card, go to the next step.For information about how to remove a transceiver module, see "Replacement procedures."3. Remove all cards from the chassis slots.Install filler panels in the corresponding slots after you remove the chassis from the rack.For information about how to remove the chassis from the rack, see "Removing the chassis from therack."For information about how to remove a card and install a filler panel, see "Replacementprocedures."4. Put the removed card into the anti-static bag.The cards on the S12500-X switch have protection boxes. Put the removed card into the protectionbox, and then put the box into the anti-static bag.5. Put the packed card into the box, and tape the flaps of the box with packing tape.Repackaging the switch chassisRemoving the chassis from the rackS12500-X switches are heavy. If possible, use a mechanical lift to move the switch.To remove the chassis from the rack:1. Prepare the wooden pallet base, carton, and packing bag of the chassis. Make sure they are clean,dry, and not damaged.