Command Manual – MSTPH3C S3100-52P Ethernet Switches Chapter 1 MSTP Configuration Commands1-25[H3C] stp interface Ethernet 1/0/3 mcheck1.1.23 stp interface no-agreement-checkSyntaxstp interface interface-type interface-number no-agreement-checkundo stp interface interface-type interface-number no-agreement-checkViewSystem viewParameterinterface-type: Port type.interface-number: Port number.DescriptionUse the stp interface no-agreement-check command to enable the rapid transitionfeature on the specified port.Use the undo stp interface no-agreement-check command to disable the rapidtransition feature on the specified port.The rapid transition feature is disabled on any port by default.Some manufactures' switches adopt proprietary spanning tree protocols that aresimilar to RSTP in the way to implement rapid transition on designated ports. When aswitch of this kind operates as the upstream switch of H3C series switches runningMSTP, the upstream designated port fails to change their states rapidly.The rapid transition feature is developed on the H3C series switches to avoid this case.When a H3C series switch running MSTP is connected in the upstream direction to amanufacture's switch adopting proprietary spanning tree protocols, you can enable therapid transition feature on the ports of the H3C series switch operating as thedownstream switch. Among these ports, those operating as the root ports will then sendagreement packets to their upstream ports after they receive proposal packets from theupstream designated ports, instead of waiting for agreement packets from theupstream switch. This enables designated ports of the upstream switch to change theirstates rapidly.Related command: stp no-agreement-check.