31CAUTION:Removing an aggregate interface also removes the corresponding aggregation group. At the same time,all member ports leave the aggregation group.Configuring a static aggregation groupNOTE:To guarantee a successful static aggregation, ensure that the ports at both ends of each link are in thesame aggregation state.Follow these steps to configure a Layer 2 static aggregation group:To do... Use the command... RemarksEnter system view system-view —Create a Layer 2 aggregateinterface and enter the Layer 2aggregate interface viewinterface bridge-aggregationinterface-numberRequiredWhen you create a Layer 2aggregate interface, the systemautomatically creates a Layer 2static aggregation groupnumbered the same.Exit to system view quit —Enter Layer 2 Ethernet interfaceviewinterface interface-typeinterface-numberRequiredRepeat these two steps to assignmultiple Layer 2 Ethernet interfacesto the aggregation group.Assign the Ethernet interface to theaggregation groupport link-aggregation groupnumberAssign the port an aggregationprioritylink-aggregation port-priorityport-priorityOptionalBy default, the aggregation priorityof a port is 32768.Changing the aggregation priorityof a port may affect theaggregation state of the ports inthe dynamic aggregation group.Configuring a dynamic aggregation groupNOTE:To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated atone end are also aggregated. The two ends can automatically negotiate the aggregation state of eachmember port.Follow these steps to configure a Layer 2 dynamic aggregation group:To do... Use the command... RemarksEnter system view system-view —
