34To do... Use the command... RemarksEnter system view system-view —Enter Layer 2 aggregate interfaceviewinterface bridge-aggregationinterface-number —Shut down the aggregate interface shutdownRequiredBy default, aggregate interfacesare up.Configuring load sharing for link aggregationgroupsConfiguring load sharing criteria for link aggregation groupsYou can determine how traffic is load-shared across a link aggregation group by configuring loadsharing criteria. The criteria can be service port numbers, IP addresses, MAC addresses, or anycombination.The switch supports configuring global and group-specific aggregation load sharing criteria. A linkaggregation group preferentially uses group-specific load sharing criteria. If no group-specific loadsharing criteria is available, the group uses the global load sharing criteria.NOTE:The load sharing criteria configuration applies to only unicast packets, and can change the load sharingcriteria for unicast packets. Broadcast packets and multicast packets always use the default load sharingcriteria.Configuring the global link-aggregation load sharing criteriaFollow these steps to configure global link-aggregation load sharing criteria:To do... Use the command... RemarksEnter system view system-view —Configure the globallink-aggregation load sharingcriterialink-aggregation load-sharing mode{ destination-ip | destination-mac |destination-port | source-ip |source-mac | source-port } *RequiredBy default, the globallink-aggregation load sharingcriteria include the source MACaddress, and destination MACaddress for Layer 2 packet typessuch as ARP, and the source IPaddresses, destination IPaddresses, source MAC addressesand destination MAC addressesfor Layer 3 packet types such as IPpackets.
