H3C S5150-EI Series Installation Manual

Also see for S5150-EI Series: Troubleshooting guide Configuration guide Command reference

Contents

15b. Slide the heat-shrink tubing onto the cable and insert the bare metal part into the end of thering terminal.c. Use a crimper to secure the metal part of the cable to the ring terminal.d. Slide the heat-shrink tubing down the cable until the tube covers the joint.e. Use a heat gun to shrink the tubing around the cable.Figure 18 Attaching a ring terminal to the grounding cable4. Connect the ring terminal to the grounding post of the grounding strip, and fasten it with theremoved hex nut.Figure 19 Connecting the grounding cable to a grounding strip(1) Grounding post (2) Grounding strip(3) Grounding cable (4) Hex nutConnecting the grounding cable to a grounding strip (S5150X-16S-EI and S5150X-16ST-EI)1. Cut the grounding cable to a length required for connecting to the grounding strip.2. Use a wire stripper to strip 20 mm (0.79 in) of insulation off the end of the grounding cable. Thenuse needle-nose pliers to bend the bare metal part to the shape as shown in Figure 20. Makesure the bended part can securely attached to the grounding post on the grounding strip.3. Attach the bended part of the grounding cable to the grounding post and use the hex nut tofasten the bended part to the post.