280• The maximum response delay for MLD general queries is set by the max-response-time command.• The maximum response delay for MLD multicast-address-specific queries equals the MLDlast-listener query interval.Configuring MLD queries and responses globallyStep Command Remarks1. Enter system view. system-view N/A2. Enter MLD-snooping view. mld-snooping N/A3. Set the maximum responsedelay for MLD generalqueries.max-response-time interval 10 seconds by default4. Set the MLD last-memberquery interval. last-listener-query-interval interval 1 second by defaultConfiguring the parameters for MLD queries and responses in a VLANStep Command Remarks1. Enter system view. system-view N/A2. Enter VLAN view. vlan vlan-id N/A3. Set the MLD query interval. mld-snooping query-intervalinterval 125 seconds by default4. Set the maximum responsedelay for MLD generalqueries.mld-snooping max-response-timeinterval 10 seconds by default5. Set the MLD last-memberquery interval.mld-snoopinglast-listener-query-interval interval 1 second by defaultConfiguring the source IPv6 addresses for MLD queriesStep Command Remarks1. Enter system view. system-view N/A2. Enter VLAN view. vlan vlan-id N/A3. Configure the source IPv6address of MLD generalqueries.mld-snooping general-querysource-ip { ipv6-address |current-interface }FE80::02FF:FFFF:FE00:0001 bydefault4. Configure the source IPv6address of MLDmulticast-address-specificqueries.mld-snooping special-querysource-ip { ipv6-address |current-interface }FE80::02FF:FFFF:FE00:0001 bydefaultIMPORTANT:The source IPv6 address of MLD query messages might affect MLD querier election within the subnet.
