281Configuring MLD snooping proxyingBefore you configure MLD snooping proxying in a VLAN, complete the following tasks:• Enable MLD snooping in the VLAN.• Determine the source IPv6 address for the MLD reports sent by the proxy.• Determine the source IPv6 address for the MLD done messages sent by the proxy.Enabling MLD snooping proxyingThe MLD snooping proxying function works on a per-VLAN basis. After you enable the function in aVLAN, the device works as the MLD snooping proxy for the downstream hosts and upstream router in theVLAN.To enable MLD snooping proxying in a VLAN:Step Command Remarks1. Enter system view. system-view N/A2. Enter VLAN view. vlan vlan-id N/A3. Enable MLD snoopingproxying in the VLAN. mld-snooping proxying enable Disabled by defaultConfiguring the source IPv6 addresses for the MLD messagessent by the proxyYou can set the source IPv6 addresses for the MLD reports and done messages that the MLD snoopingproxy sends on behalf of its attached hosts.To configure the source IPv6 addresses for the MLD messages that the MLD snooping proxy sends in aVLAN:Step Command Remarks1. Enter system view. system-view N/A2. Enter VLAN view. vlan vlan-id N/A3. Configure a source IPv6address for the MLDreports that the proxysends.mld-snooping report source-ip{ ipv6-address | current-interface }The default isFE80::02FF:FFFF:FE00:0001.4. Configure a source IPv6address for the MLDdone messages that theproxy sends.mld-snooping done source-ip{ ipv6-address | current-interface }The default isFE80::02FF:FFFF:FE00:0001.
