H3C S5560S-SI Installation Manual

Also see for S3100V3-SI: Troubleshooting guide Troubleshooting guide Installation guide Installation guide

Contents

H3C S5560S-SI Installation Manual Manual pdf 11 page image

3Switch series Model Product codeS3100V3-SIswitch seriesNon-PoEmodelsS3100V3-10TP-SI LS-3100V3-10TP-SIS3100V3-18TP-SI LS-3100V3-18TP-SIS3100V3-28TP-SI LS-3100V3-28TP-SIS3100V3-52TP-SI LS-3100V3-52TP-SIPoE modelsS3100V3-10TP-PWR-SI LS-3100V3-10TP-PWR-SIS3100V3-20TP-PWR-SI LS-3100V3-20TP-PWR-SIS3100V3-28TP-PWR-SI LS-3100V3-28TP-PWR-SISafety recommendationsTo avoid equipment damage or bodily injury, read the following safety recommendations beforeinstallation. Note that the recommendations do not cover every possible hazardous condition.• Before cleaning the switch, remove all power cords from the switch. Do not clean the switchwith wet cloth or liquid.• Do not place the switch near water or in a damp environment. Prevent water or moisture fromentering the switch chassis.• Do not place the switch on an unstable case or desk. The switch might be severely damaged incase of a fall.• Ensure good ventilation at the installation site and keep the air inlet and outlet vents of theswitch free of obstruction.• Make sure the operating voltage is as required.• To avoid electrical shocks, do not open the chassis while the switch is operating or when theswitch is just powered off.• Always wear an ESD wrist strap when installing the switch. Make sure the strap makes goodskin contact and is reliably grounded.Examining the installation siteThe switch must be used indoors. You can mount your switch in a rack or on a workbench, but makesure of the following information:• Adequate clearance is reserved at the air inlet and exhaust vents for ventilation.• The rack or workbench has a good ventilation system.• Identify the cold aisle and hot aisle at the installation site, and make sure ambient air flows intothe switch from the cold aisle and exhausts to the hot aisle.• Identify the airflow directions of the upper and lower devices and prevent hot air exhausted fromthe lower devices from flowing into the upper devices.• The rack is sturdy enough to support the switch and its accessories.• The rack or workbench is reliably grounded.To ensure correct operation and long service life of your switch, install it in an environment that meetsthe requirements described in the following subsections.