H3C S5810-50S Installation Manual

Also see for S5810-50S: Quick start

Contents

5-16Enter your choice(0-3):5) Configure the switch to load the Boot ROM file through FTPIn the protocol parameter setting menu, enter 2 to update the Boot ROM file using FTP, and then set theFTP parameters.Load File Name :update.binServer IP Address :10.10.10.2Local IP Address :10.10.10.3Gateway IP Address :0.0.0.0FTP User Name :5810FTP User Password :123The parameters are described in Table 5-6.Table 5-6 Description of the FTP parametersItem DescriptionLoad File Name : Name of the file to be downloadedServer IP Address : IP address of the PCLocal IP Address : IP address of the switchGateway IP Address : IP address of the gatewayFTP User Name Username for logging in to the FTP server, which should be consistentwith that configured on the FTP server.FTP User Password Password for logging in to the FTP server, which should be consistentwith that configured on the FTP server.z Enter the file name and IP addresses based on the actual condition.z If the switch and the server are on the same network segment, you can specify any unused IPaddress of the network for the switch without specifying the gateway’s IP address; if they are not onthe same segment, you need to specify the gateway’s IP address so that the switch cancommunicate with the server.6) Update the Boot ROM file on the switchEnter the corresponding parameters based on the actual condition. The system displays the followinginformation:Will you Update Basic BootRom? (Y/N):YThe system asks you whether you want to update the basic Boot ROM section. Click Y. The systemdisplays the following information after the update is complete:Updating Basic BootRom...........Done!Updating extended BootRom? (Y/N):YThe system asks you whether you want to update the extended Boot ROM section. Click Y and then thesystem displays the following information after the update is complete:Updating extended BootRom.........Done!