H3C S5810-50S Installation Manual

Also see for S5810-50S: Quick start

Contents

5-177) Restart the switch to make the updated Boot ROM file effectivePress any key to return to the Boot ROM update menu.Press enter key when ready1. Update full BootRom2. Update extended BootRom3. Update basic BootRom0. Return to boot menuEnter your choice(0-3):Enter 0 to return to the Boot ROM menu, and then enter 0 again. After that, the device is restarted andthe updated Boot ROM file becomes effective.Loading an application fileTo load an application file of the switch, enter 1 in the Boot ROM menu. The system displays thefollowing information:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3You can enter 2 to load the application file.The procedure of loading an application file is similar to that of upgrading the Boot ROM program. Thedifference lies in that the system displays the prompt of loading the application file rather than upgradingthe Boot ROM program.After loading the application file, the switch displays that you should configure the application attribute,that is, main, backup, or none. Type a specific attribute to complete loading the application file.Writing flash..................................................................................Done!Please input the file attribute (Main/Backup/None) MDone!If an application file with a specific attribute already exists when you set a new file with the attribute, theattribute of the existing file becomes none after the new file becomes effective.Loading Software Through CLIBy connecting a terminal to the switch, you can upgrade the Boot ROM program and load applicationfiles of the switch remotely through CLI.