2-30[DeviceA-nqa-admin-test-http] http-version v1.0# Enable the saving of history records.[DeviceA-nqa-admin-test-http] history-record enable[DeviceA-nqa-admin-test-http] quit# Enable HTTP test.[DeviceA] nqa schedule admin test start-time now lifetime forever# Disable HTTP test after the test begins for a period of time.[DeviceA] undo nqa schedule admin test# Display results of the last HTTP test.[DeviceA] display nqa result admin testNQA entry(admin admin, tag test) test results:Destination IP address: 10.2.2.2Send operation times: 1 Receive response times: 1Min/Max/Average round trip time: 64/64/64Square-Sum of round trip time: 4096Last succeeded probe time: 2007-11-22 10:12:47.9Extended results:Packet lost in test: 0%Failures due to timeout: 0Failures due to disconnect: 0Failures due to no connection: 0Failures due to sequence error: 0Failures due to internal error: 0Failures due to other errors:Packet(s) arrived late: 0# Display the history of HTTP tests.[DeviceA] display nqa history admin testNQA entry(admin admin, tag test) history record(s):Index Response Status Time1 64 Succeeded 2007-11-22 10:12:47.9UDP Jitter Test Configuration ExampleNetwork requirementsAs shown in Figure 2-8, use the NQA UDP jitter function to test the delay jitter of packet transmissionbetween Device A and Device B.Figure 2-8 Network diagram for UDP jitter testsConfiguration procedure1) Configure Device B# Enable the NQA server and configure the listening IP address as 10.2.2.2 and port number as 9000. system-view[DeviceB] nqa server enable
