29Connecting the physical IRF portsUse category-6A or above twisted pair/SFP+/QSFP+ cables or SFP+/QSFP+ transceiver modulesand fibers to connect the IRF member switches as planned.NOTE:Wear an ESD wrist strap when you connect SFP+ cables or SFP+ transceiver modules and fibers.For more information, see SFP/SFP+/XFP Transceiver Modules Installation Guide and QSFP+Transceiver Modules/Cables Installation Guide.Accessing the IRF fabric to verify the configurationTo verify the basic functionality of the IRF fabric after you finish configuring basic IRF settings andconnecting IRF ports:1. Log in to the IRF fabric through the console port of any member switch.2. Create a Layer 3 interface, assign it an IP address, and make sure the IRF fabric and theremote network management station can reach each other.3. Use Telnet, web, or SNMP to access the IRF fabric from the network management station. (SeeH3C S6520-EI Switch Series Fundamentals Configuration Guide.)4. Verify that you can manage all member switches as if they were one node.5. Display the running status of the IRF fabric by using the commands in Table 4.Table 4 Displaying and maintaining IRF configuration and running statusTask CommandDisplay information about the IRF fabric. display irfDisplay all members’ IRF configurations. display irf configurationDisplay IRF fabric topology information. display irf topologyNOTE:To avoid IP address collision and network problems, configure at least one multi-active detection(MAD) mechanism to detect the presence of multiple identical IRF fabrics and handle collisions. Formore information about MAD detection, see H3C S6520-EI Switch Series IRF Configuration Guide.