H3C S7500 Series Operation Manual

Also see for S7500 Series: Operation manual Operation manual Operation manual Operation manual Command manual

H3C S7500 Series Operation Manual Manual pdf 24 page image

Operation Manual – MSTPH3C S7500 Series Ethernet Switches Chapter 1 MSTP Configuration1-22To do ... Use the command ... RemarksSpecify whether ornot the linkconnected to theport is apoint-to-point linkstp point-to-point{ force-true | force-false |auto }RequiredThe auto keyword is adoptedby default.The force-true keywordspecifies that the linkconnected to the port is apoint-to-point link.The force-false keywordspecifies that the linkconnected to the port is not apoint-to-point link.The auto keyword specifies toautomatically determinewhether or not the linkconnected to the port is apoint-to-point link.Note:Among aggregated ports, you can configure only the links of master ports aspoint-to-point links. If an auto-negotiating port operates in full duplex mode afternegotiation, you can configure the link of the port as a point-to-point link.After you configure the link of a port as a point-to-point link, the configuration applies toall MSTIs. If the actual physical link of a port is not a point-to-point link and you forciblyconfigure the link as a point-to-point link, temporary loops may be incurred.III. Configuration example# Configure the link connected to Ethernet2/0/1 as a point-to-point link.1) Configure in system view. system-view[H3C] stp interface ethernet2/0/1 point-to-point force-true2) Configure in Ethernet port view. system-view[H3C] interface ethernet2/0/1[H3C-Ethernet2/0/1] stp point-to-point force-true1.2.13 MSTP ConfigurationI. Configuration procedureFollow these steps to enable/disable MSTP in system view:

/ 47

Related manuals for H3C S7500 Series

H3C S7500 Series Operation Manual

This manual is suitable for:

S7500 Series

manualsdatabase

Your AI-powered manual search engine