H3C S7500 Series Operation Manual

Also see for S7500 Series: Operation manual Operation manual Operation manual Operation manual Command manual

H3C S7500 Series Operation Manual Manual pdf 26 page image

Operation Manual – MSTPH3C S7500 Series Ethernet Switches Chapter 1 MSTP Configuration1-242) Configure in Ethernet port view. system-view[H3C] stp enable[H3C] interface ethernet2/0/1[H3C-Ethernet2/0/1] stp disable1.3 Leaf Node ConfigurationComplete the following tasks to configure leaf node:Task RemarksMSTP ConfigurationRequiredTo prevent network topology jittercaused by other related configurations,you are recommended to enable MSTPafter performing other configurations.MST Region Configuration RequiredMSTP Operation Mode Configuration OptionalTimeout Time Factor Configuration OptionalMaximum Transmitting SpeedConfigurationOptionalThe default value is recommended.Edge Port Configuration OptionalPath Cost Configuration OptionalPort Priority Configuration OptionalPoint-to-point Link-RelatedConfiguration OptionalNote:In a network that contains switches with both GVRP and MSTP employed, GVRPpackets are forwarded along the CIST. If you want to broadcast packets of a specificVLAN through GVRP, be sure to map the VLAN to the CIST when configuring theMSTP VLAN mapping table (the CIST of a network is the MSTI numbered 0.)1.3.1 Configuration PrerequisitesThe status of the switches in the spanning trees is determined. That is, the status (root,branch, or leaf) of each switch in each MSTI is determined.

/ 47

Related manuals for H3C S7500 Series

H3C S7500 Series Operation Manual

This manual is suitable for:

S7500 Series

manualsdatabase

Your AI-powered manual search engine