H3C S9500 Series Command Manual

Also see for S9500 Series: Operation manual Operation manual Operation manual Operation manual Operation manual

Contents

H3C S9500 Series Command Manual Manual pdf 31 page image

Command Manual – RPRH3C S9500 Series Routing Switches Chapter 1 RPR Port Configuration Commands1-29DescriptionUse the port-type command to set the 10G RPR board mode. After the mode changessuccessfully, the board restarts automatically for the port to switch to new RPR porttype.Caution:z This command is only available to 10G RPR ports. A 2.5G RPR port supports onlythe POS mode, and a GE RPR port supports only the RprGE mode.z After you change the port type of an RPR port and the card restarts, the existingconfiguration of the port will be automatically removed. Therefore, you need toconfigure the port again.Examples# Set RPR port type to 10GE. system-view[H3C] interface RprPos 3/1/1[H3C-RprPos3/1/1] port-type 10ge1.1.19 reset counters interfaceSyntaxreset counters interface [ interface-type interface-number ]ViewUser viewParametersinterface-type: Interface type.interface-number: Port number, in the format of slot number/card number/port number.The port can be an RPRPOS logical interface or physical port.DescriptionUse the reset counters interface command to clear port statistics to implementstatistics of related information on the port..Examples# Clear the statistics on RPRPOS 2/1/1.

/ 65

Related manuals for H3C S9500 Series

H3C S9500 Series Command Manual

This manual is suitable for:

S9500 Series

manualsdatabase

Your AI-powered manual search engine