H3C S9500 Series Command Manual

Also see for S9500 Series: Operation manual Operation manual Operation manual Operation manual Operation manual

Contents

H3C S9500 Series Command Manual Manual pdf 44 page image

Command Manual – RPRH3C S9500 Series Routing SwitchesChapter 2 RPR Layer 2 Tunnel Extended ApplicationConfiguration Commands2-1Chapter 2 RPR Layer 2 Tunnel ExtendedApplication Configuration Commands2.1 RPR Layer 2 Tunnel Extended Application ConfigurationCommands2.1.1 display rpr tunnel-tableSyntaxdisplay rpr tunnel-table [ vlan vlanid [ range number ] ] [ valid | invalid ][ interface-type interface-number ]ViewAny viewParametersvlanid: Start VLAN ID of the VLAN ID range.range number: Number of the VLANs apart from the start VLAN.valid: Displays the valid entries only.invalid: Displays the invalid entries only.interface-type: Port type.interface-number: Port number.DescriptionUse the display rpr tunnel-table command to display the information about an RPRtunnel.This command can also display the information about all the tunnels or display tunnelinformation according to VLAN, tunnel state (valid or invalid), or port number.Examples# Display the information about all the RPR Layer 2 tunnels. display rpr tunnel-tableTunnel vlan table of interface: RprPos4/1/1Vid - Vlan ID, DA - Dest Mac Address, CA - Current Mac Address,ARi - Actual Ringlet,CRi - Configed Ringlet, F - Force Ringlet,

/ 65

Related manuals for H3C S9500 Series

H3C S9500 Series Command Manual

This manual is suitable for:

S9500 Series

manualsdatabase

Your AI-powered manual search engine