H3C S9500 Series Command Manual

Also see for S9500 Series: Operation manual Operation manual Operation manual Operation manual Operation manual

Contents

H3C S9500 Series Command Manual Manual pdf 64 page image

Command Manual – RPRH3C S9500 Series Routing SwitchesChapter 5 Distributed RPR ConfigurationCommands5-3Parametersagg-id: ID of the aggregation group, ranging from 1 to 31. The group ID ranges from 1to 7 if a C-type board is used. Only manual aggregation group can be used fordistributed RPR.DescriptionUse the link-aggregation group mode manual command to create a manualaggregation group for distributed RPR.Use the undo link-aggregation group command to remove the specified aggregationgroup.Related commands: display rpr link-aggregation.Note:The manual aggregation group configuration aggregates two RPR logical interfaces,implementing board-level protection for distributed RPR.Examples# Create manual aggregation group 1 for distributed RPR. system-viewSystem View: return to User View with Ctrl+Z.[H3C] link-aggregation group 1 mode manual5.1.4 port link-aggregation groupSyntaxport link-aggregation group agg-idundo port link-aggregation groupViewRPR logical interface viewParametersagg-id: ID of an aggregation group, ranging from 1 to 31. The group ID ranges from 1 to7 if a C-type board is used. At present only RPR logical interfaces can be added to amanual aggregation group.

/ 65

Related manuals for H3C S9500 Series

H3C S9500 Series Command Manual

This manual is suitable for:

S9500 Series

manualsdatabase

Your AI-powered manual search engine