63Priority mapping configuration commandsNOTE:The commands in this chapter are aivalable on only a SAP interface card working in bridge mode.Priority mapping table configuration commandsdisplay qos map-tableSyntaxdisplay qos map-table [ dot1p-dp | dot1p-lp | dscp-dot1p| dot1p-exp | dscp-dp | dscp-dscp |exp-dot1p | exp-dp ] [ | { begin | exclude | include } regular-expression ]ViewAny viewDefault level1: Monitor levelParametersdot1p-dp: 802.1p-to-drop priority mapping table.dot1p-lp: 802.1p-to-local priority mapping table.dot1p-exp: 802.1p-to-EXP priority mapping table.dscp-dot1p: DSCP-to-802.1p priority mapping table.dscp-dp: DSCP-to-drop priority mapping table.dscp-dscp: DSCP-to-DSCP priority mapping table.exp-dot1p: EXP-to-802.1p priority mapping table.exp-dp: EXP-to-drop priority mapping table.|: Filters command output by specifying a regular expression. For more information about regularexpressions, see the Fundamentals Configuration Guide.begin: Displays the first line that matches the specified regular expression and all lines that follow.exclude: Displays all lines that do not match the specified regular expression.include: Displays all lines that match the specified regular expression.regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.DescriptionUse the display qos map-table command to display the configuration of a priority mapping table.