48# Display the most recent result of the SNMP operation.[DeviceA] display nqa result admin test1NQA entry (admin admin, tag test1) test results:Send operation times: 1 Receive response times: 1Min/Max/Average round trip time: 50/50/50Square-Sum of round trip time: 2500Last succeeded probe time: 2011-11-22 10:24:41.1Extended results:Packet loss ratio: 0%Failures due to timeout: 0Failures due to internal error: 0Failures due to other errors: 0# Display the history records of the SNMP operation.[DeviceA] display nqa history admin test1NQA entry (admin admin, tag test1) history records:Index Response Status Time1 50 Succeeded 2011-11-22 10:24:41.1The output shows that it took Device A 50 milliseconds to receive a response from the SNMPagent.TCP operation configuration exampleNetwork requirementsAs shown in Figure 14, configure a TCP operation to test the time required for Device A and Device B toestablish a TCP connection.Figure 14 Network diagramConfiguration procedure1. Assign each interface an IP address. (Details not shown.)2. Configure static routes or a routing protocol to make sure the devices can reach each other.(Details not shown.)3. Configure Device B:# Enable the NQA server. system-view[DeviceB] nqa server enable# Configure a listening service to listen on the IP address 10.2.2.2 and TCP port 9000.[DeviceB] nqa server tcp-connect 10.2.2.2 90004. Configure Device A:# Create a TCP operation. system-view[DeviceA] nqa entry admin test1
