H3C SecPath F5020 Installation Manual

Also see for SecPath F5020: Configuration guide Installation, quick start Manual Interface configuration guide

Contents

H3C SecPath F5020 Installation Manual Manual pdf 33 page image

26• Username—admin• Password—adminTo access the device from the console port:1. Use a console cable to connect the console port on the device to a configuration terminal, forexample, a PC.2. Run a terminal emulator program, TeraTermPro or PuTTY, on your configuration terminal.For more information about the terminal emulator programs, see the user guides for theseprograms.3. Configure the terminal settings as follows:{ Bits per second—9,600.{ Data bits—8.{ Stop bits—1.{ Parity—None.{ Flow control—None.Logging in from the Web interfaceIMPORTANT:After accessing the Web interface with the default account, modify the password of the defaultaccount or create a new administrator account and delete the default account as a best practice.At the first login from the Web interface, you can use the default account or use an account createdfrom the CLI.The default Web interface login information is as follows:• Username—admin• Password—admin• IP address of GigabitEthernet 1/0/0—192.168.0.1/24To log in to the device from the Web interface by using the default account:1. Use an Ethernet cable to connect a PC to Ethernet management port GigabitEthernet 1/0/0 onthe device.2. Configure an IP address in subnet 192.168.0.0/24 for the PC. Make sure the PC and the deviceare reachable to reach other.The PC must use a different IP address than GigabitEthernet 1/0/0.3. Start a browser, enter 192.168.0.1 in the address bar, and press Enter.4. Enter the default username admin and password admin and then click Login.Logging in through Telnet1. Log in to the device through the console port, and enable the Telnet function in system view byusing the telnet server enable command.2. Enter VTY user line view, and configure the authentication mode, user role, and commonproperties.By default, the authentication mode is scheme, the username is admin, and the password isadmin.3. Specify an IP address for the PC. Make sure the PC and the device are reachable to eachother.By default, the IP address of GigabitEthernet 1/0/0 on the device is 192.168.0.1/24.