H3C WA Series Command Reference Manual

Also see for WA Series: Configuration guide Getting started guide Configuration guide Layer 2 command reference Command reference

Contents

H3C WA Series Command Reference Manual Manual pdf 27 page image

5-6Examples# Enable the WPA-IE in the frames. system-view[Sysname] wlan service-template 1 crypto[Sysname-wlan-st-1] security-ie wpatkip-cm-timeSyntaxtkip-cm-time timeundo tkip-cm-timeViewWLAN service template view (crypto type)Default Level2: System levelParameterstime: Counter measure time for Message Integrity Check (MIC) failure in seconds. The value rangesfrom 0 to 3600 seconds.DescriptionUse the tkip-cm-time command to set the Temporal Key Integrity Protocol (TKIP) Counter measuretime.Use the undo tkip-cm-time command will change the TKIP counter measure time to the default value.By default, the TKIP counter measure time is 0 seconds, that is, no counter measures are taken.After countermeasures are enabled, if more than two MIC failures occur within a certain time, the TKIPassociations are disassociated, and new associations are allowed to establish only after the specifiedTKIP counter measure time expires.Examples# Set the TKIP counter measure time to 90 seconds. system-view[Sysname] wlan service-template 1 crypto[Sysname-wlan-st-1] tkip-cm-time 90wep default-keySyntaxwep default-key key-index { wep40 | wep104 | wep128} { pass-phrase | raw-key } [ cipher | simple ]keyundo wep default-key key-indexViewWLAN service template view (crypto type)Default Level2: System level