HAI OMNI IIe Owner's Manual

Also see for OMNI IIe: Installation manual Installation

Contents

HAI OMNI IIe Owner's Manual Manual pdf 113 page image

Page 105User SetupEach Access Control Card and Key Tag used is assigned to a code in the HAI controller. The Access Control Card or Key Tag isgoverned by the validation times/days set for the code (i.e. the Access Control Card or Key Tag is only valid when the code isvalid).Note: An Access Control Card or Key Tag may be assigned to a code even if the code is disabled (i.e. the user code is set to0000). Even if the code is disabled, the Access Control Card or Key Tag may be used if it is currently valid.Each Access Control Card and Key Tag can be:• Enrolled• Deleted• Enabled and disabled• Assigned to specific Access Control Readers• Configured to log activity• Configured for arming and disarming privilegesAccess Control Cards and Key Tags can easily be enrolled and configured using an HAI console or PC Access software. AccessControl Cards and Key Tags are enrolled and configured under Setup | Codes.Enrolling Access Control Cards or Key TagsTo enroll Access Control Cards or Key Tags, from the Setup menu, press the 1 (CODES) key. Use the down arrow key to scrollto the “Card Number” menu item. Access Control Cards or Key Tags can be enrolled into the system using one of the followingmethods:Method A) Typing in the ID Number of the Access Control Card or Key Tag:a. Enter the last 8 digits of the Access Control Card or Key Tag and then press the ' # ' key.CARD 1 NUMBER:000 00000 #=CFG ¦CARD 1 NUMBER:095 13564 #=DEL ¦Method B) Enter configuration mode and then swipe the card 3 times at any Access Control Reader configured in thesystem:a. Press the ' # ' (#=CFG) key to put the system into configuration mode. The display will show:CONFIGURE CARD 1SWIPE CARD 3 TIMESb. Go to any Access Control Reader configured in the system, and swipe the Access Control Card or KeyTag 3 times in front of the reader:CARD 1 NUMBER:095 13564 #=DEL ¦Note: you have 3 minutes to complete the operation once the system is put into configuration mode. If an HAI Access ControlCard or Key Tag has not been swiped 3 times within the first 3 minutes, the controller will automatically exit configuration mode.