Hach sc200 User Manual

Also see for sc200: Quick guide Software update Basic user manual User manual User manual

Hach sc200 User Manual Manual pdf 47 page image

the devices again and push ENTER. Wait for the "Transfer complete"message.6. Push ENTER again to return to the Manage Configuration menu.Restore settings to the controllerThis menu selection only appears if a (serial number-specific) backup filefor the controller or one of the sensors connected to it exists on the SDCard. This menu selection loads the configuration of a specific devicefrom the SD card to the same device (serial number-controlled function).1. Push the MENU key.2. Select SD Card Setup and push ENTER.3. Select Manage Configuration and push ENTER.4. Select Restore Settings and push ENTER.5. Select the device that will be restored. All devices are selected bydefault. To deselect an item, highlight the selection and push the leftarrow key. Push ENTER to begin the file transfers.6. When the transfer is complete, push ENTER.7. To have the settings take effect immediately, restart the controller.Push the BACK key to exit the Manage Configuration menu.Transfer settings to another deviceAll device settings including calibration, sensor name, selectedtemperature and measurement units and data logging settings aretransferred.1. Push the MENU key.2. Select SD Card Setup and push ENTER.3. Select Manage Configuration and push ENTER.4. Select Transfer Settings and push ENTER. Two options appear:• Retrieve Settings• Copy Settings5. To retrieve settings from the controller (or a device connected to it)and put the settings on the SD card:a. Select Retrieve Settings and push ENTER.b. Select the devices that contain the information to be transferred.All devices are selected by default. To deselect an item, highlightthe selection and push the left arrow key. Push ENTER to beginthe file transfers. Wait for the "Transfer complete" message.c. If files already exist on the SD card, a confirmation windowappears. Select the devices again and push ENTER. Wait for the"Transfer complete" message.d. Push ENTER to return to the Manage Configuration menu.6. To copy settings from the SD card to a controller (or a deviceconnected to it):a. Select Transfer Settings and push ENTER.b. Select Copy Settings and push ENTER.c. Select the devices on the SD card. All devices are selected bydefault. To deselect an item, highlight the selection and push theleft arrow key. Push ENTER to begin the file transfers.7. When the transfer is complete, push ENTER to restart the connecteddevices.8. Push ENTER to restart the controller or push BACK to return to theManage Configuration menu.Using the service portThe service port is used to download data files from the controller andinstall new versions of controller and sensor firmware. To download dataand update software, use the service port in combination with DataComand a service cable (L=X887).Using DataComWhen using the service port, it is necessary to use DataCom. DataComis a PC Application Utility that downloads data log and event log filesfrom the controller and installed sensors. Files are downloaded from thecontroller through the controller service port or they can be placed on aSecure Digital Memory (SD) card installed in the controller. In addition,(nglisK 41