Haier AB142ACNBC Operation Manual

Haier AB142ACNBC Operation Manual Manual pdf 9 page image

7Clock SetDisplay when healthy run function is set.14.TIMER OFF Display15.HUMIDIFICATION Display16.TEMPERATURE Display17.LOCK State Display18.BATTERY Energy DisplayDisplay when in low battery to remindcustomer to change the battery.19.STRONG/QUITE Run Display20.SIGNAL SENDING Display21.NEW AIR Display22.ELECTRICAL HEATING Display23.HEALTH Display24.SLEEP State Display25.Operation MODE DisplayAUTO RUN COOL RUN DRY RUN FAN RUN26.COMFORTABLE RUN Display27.FAN SPEED Display28.AUTO SWING Display29.TIMER Display30.FILTER Display31.TIMER ON DisplayRemote Controllerí OperationThe distance between the signal transm-ission head and the receiver hole shouldbe within 7m without any obstacle as well.When unit is started for the first time and after replacing batteries in remotecontroller, clock should be adjusted as follows:1.Press CLOCK button,clock indication of ì AM ì or ìPMî flashes.2.Press or to set correct time,each press will increase or decrease1 min. If the button is kept pressed, time will increase or decrease quickly.3.After time setting is confirmed,press ìSETî , AM or PM stop flashing,while clock starts working.Note:AM means morning and PM means afternoon.Donít throw the controller,prevent it frombeing damaged.When in use, put the signal transmissionhead directly to the receiver hole on theindoor unitWhen electronic-strated type fluorescent lamp orchange-over type fluorescent lamp or wirelesstelephone is installed in the room, the receiver isapt to be disturbed in receiving the signals so thedistance to the indoor unit should be shorter.Loading of the battery (load the batteriesas illustrated)Remove the battery coverLoad the batteryPut on the cover againInstalling the cover is opposite to removing itConfirmation indicatorIf no indication after press ON/OFF button,reloadthe batteries.Note:AUTOLOMIDHIAUTOUse two new same-typed batteries when loading.If the remote controller canít run normally duringoperation ,please remove the batteries and reloadthem few minutes later that will be okIf the display of remote controller is faded(someti-mes run abnormally),which indicates no battery,soplease change the batteriesHint:Remove the batteries in case unit will not be inusage for a long period.if there is any display aftertaking-out just need to press reset button with asharp article.When throw away the waste batteries, pleaseperform in accordance with the local regulation.When throw away the waste batteries, pleaseperform in accordance with the local regulation.First slightly press the position marked withand push down the cover,then as shown in thefigure:holding the upper part of the remote con-troller with the left hand and the right handslightly grasps the battery box cover and forceson the arrow direction to remove the cover.SLEEPSETTIMERLOCK RESETMODECLOCK1Be sure that the loading is in line with the ì + î ì - îpole request as illustrated on the botton of the box.Remote Controller Functions2 3