Haier AB242ACBEA Service Manual

Also see for AB242ACBEA: Service manual Manuel d'utilisation Operation and installation manual

5 _ 8mm32214Holding ringPiping hole positionSwing flap motorFig. 7SealIndoor unitCeiling materialOrnament panel(2) Remove cover plate at cornerTear off the adhesive tape,and slide it off.(Refer to Fig. 3)(1)(2)2. Install ornament panel on indoor unit.As shown in Fig . 7, match the position ofswing flap motor with that of the indoor unitpiping hole , so that ormament panel can beplaced on to indoor unit.Installation of ornament panelPlace the holding ring on swing flao motorside teporarily on hooks of the indoor unit.(2 pcs)Put the other two holding rings on the hooks atboth side of the indoor unit. (Care should betaken not to push wiring of swing flap motorinto seals).Screw in all 4 screws under holding ring forabout 15mm. (Pancl will rise).Adjust the ornament panel as per Fig. 7 tocover opening on the ceiling.Tighten screws to redrce the thickness of sealsbetween ornament and indoor unit to 5-8mm.12345If indoor unit is at horizontal leveland water drainage is smooth,then, indoor unit height can be ad-justed throrgh holes at corners ofornament panel.If screws are not tighten tight, problems in Fig, 8might occur. Tighten screws properly.If there are still space after tighteningof screws, please readjust the heightof indoor unit. (Refer to Fig. 9)Leave no space. Fig. 9Gas leakage.Gas leakage from roof.Contamination Mist exists and drop down.Fig. 845Fig. 2Adhesive tapeSlideFig. 3For indoor unit installation, please refer to Installation Manual. HookCaution12Leave no space.Fig. 63. Mounting on high ceiling(1) Ornament panel can be mounted on ceiling as high as 3 m.(2) Please install pad as accessary.Cut open the pad along cutting ling. Use part a only and discard part b . (Refer to Fig. 4)Install part a of the pad on the place shown in Fig. 5. Refer to Fig. 6.Fig. 4(3)Wiring on ornament panelConnecting of wiring of the swingflap motor on ornament panel. (2 places)(Refer to Fit . 10)50Cutting line100a bPlace it on the frame.Part a of the padPart a of the padSwing flap motor Fig. 5Side of ornament panelFig. 10Wiring diagramSide of indoor unitIf connecting is not made, error code(A7) appears on remote controller. So,make proper connecting.INSTALLATION INSTRUCTIONS