Haier AB242ACBEA Service Manual

Also see for AB242ACBEA: Service manual Manuel d'utilisation Operation and installation manual

Clock SetDisplays when healthy run function is set.22.TEMPERATURE Display34.LOCK State Display33.BATTERY Energy DisplayNotify the user when it is time to changethe batteries.24.HIGH/SO Display25.SIGNAL SENDING Display26.FRESH AIR Display27.ELECTRICAL HEATING Display29.HEALTH Display32.SLEEP State Display31.Operation MODE DisplayAUTO RUN COOL RUN DRY RUN HEAT RUN FAN RUN35.FAN SPEED Display23.AUTO SWING Display19.TIMER OFF Display21.FILTER Display36.TIMER ON DisplayWhen unit is started for the first time and after replacing batteries in remotecontroller, clock should be adjusted as follows:1.Press CLOCK button, clock indication of " AM " or " PM " flashes.2.Press or to set correct time. Each press will increase or decrease1 min. If the button is kept pressed, time will increase or decrease quickly.3.After time setting is confirmed, press "SET" : AM or PM stop flashing,while clock starts working.Note:AM means morning and PM means afternoon.When operating the remote controller in an area whereelectronically controlled lights are installed or wireless handsetsare used, please move closer to the indoor unit as the functionof the remote controller might be affected by signals emittedby the above mentioned equipments.Battery loadingConfirmation indicatorIf no indication is displayed after press ON/OFF button,reload the batteries.AUTOLOMIDHIAUTORemote Controller' OperationWhen in use, direct signal transmissionhead to the receiver placed on the indoorunitThe distance between the remote controller and the receivershould be max 7m and there should be no obstacle between them.Do not throw the remote controller; prevent it from beingdamaged.18.FAN ButtonUsed to select fan speed:LOW,MID,HIGH,AUTO.Note:It is recommended that the batteries be removed from thecompartment if the remote controller is not used for an extendedperiod.The remote controller is programmed for automatic test ofoperation mode after the batteries are replaced. When the testis conducted, all icons will appear on the screen and thendisappear if the batteries are properly fitted.Caution:If the remote controller does not operate as designed afterfitting new batteries of the sametype, press the Reset button (marked ) with a pointed article.20.CLOCK Display30.DEHUMIDIFICATION Display28.Some other buttonsAll these functions are not available now.FRESHHIGH/SOTIMERSETFILTERHEALTHRESET LOCKSLEEPMODECLOCKCODE LIGHT321Battery loadingBatteries are fitted as follows:Loading the batteryEnsure that batteries are correctly placed in the compartmentas required for positive and negative terminals.Replacing the battery compartment lidThe battery compartment lid is reinstalled in the reversesequence.Display reviewPress the button to see if batteries are properly fitted. Ifno display appears, refit the batteries.Remove the battery compartment lidSlightly press and disengage the battery compartment lid markedwith ì î and then hold the remote controller by the uppersection and then remove the battery compartment lid by pressingin the direction of the arrow as shown in the figure above.* ** *