9AUTO, COOL , HEAT and DRY Operation1. Unit startPress ON/OFF button,unit starts.Previous operation status appears on LCD (except forTIMER,SLEEP and SWING setting)3.Temperature settingThen select AUTO run or select COOL operation orselect DRY operation or select HEAT operation2.Select operation modePress MODE button. At each press, operation modechanges as follows:Press TEMP button.Every time the button is pressed, temp. setting increases1 C; if the button is kept pressed, temp. setting will increasequickly.Every time the button is pressed, temp. setting decreases1 C, if the button is kept pressed, temp. setting will decreasequickly.Set proper temperature4.Adjust FAN buttonPress FAN button. At each press, fan speed changes as follows:Air conditioner will run at the selected fan speed.5. Unit stopPress ON/OFF button,unit stops.In ATUO mode, the temperature setting is not displayed on LCD. In this mode, during running air conditionerwill select COOL, HEAT or FAN mode automatically according to the room temperature.In DRY mode, when room temperature becomes 2 C higher than temperature setting, unit will run intermittentlyat LOW speed regardless of FAN setting. When room temperature is lower than temperature setting, unit willonly run FAN operation.In HEAT mode,warm air will blow out after a short period of time due to cold-draft prevention function.AUTO FANHEATCOOL DRYAUTO LOW MID HIGHFRESHHIGH/SOTIMERSETFILTERAHEALTHRESET LOCKSLEEPFANTEMPONOFFSWINGMODECLOCKCODE LIGHTAUTOHEATTemp. setting +2 CTemp.settingOn reaching temp.setting+2 C, unit will run in mildDRY mode.Ultra-low air flowCOOL operation startswhen room temp.ishigher than temp.setting.35 1342AUTO