Haier AF072XCBAA Operation And Installation Manual

Also see for AF072XCBAA: Service manual Service manual

Contents

8Parts and FunctionsClock SetDisplays when healthy run function is set.22.TEMPERATURE Display34.LOCK State Display33.BATTERY Energy DisplayNotify the user when it is time to changethe batteries.24.HIGN/SO Run Display26.SIGNAL SENDING Display28.Fresh Display29.Auxiliary ELECTRICAL HEATING Display30.HEALTH Display32.SLEEP State Display31.Operation MODE DisplayAUTO RUN COOL RUN DRY RUN HEAT RUN FAN RUN35.FAN SPEED Display23.AUTO SWING Display20.TIMER Display21.FILTER Display36.TIMER ON DisplayWhen unit is started for the first time and after replacing batteries in remotecontroller, clock should be adjusted as follows:1.Press CLOCK button, clock indication of " AM " or " PM " flashes.2.Press or to set correct time. Each press will increase or decrease1 min. If the button is kept pressed, time will increase or decrease quickly.3.After time setting is confirmed, press "SET" : AM or PM stop flashing,while clock starts working.Note:AM means morning and PM means afternoon.When operating the remote controller in an area whereelectronically controlled lights are installed or wirelesshandsets are used, please move closer to the indoor unitas the function of the remote controller might be affectedby signals emitted by the above mentioned equipments.Battery loadingConfirmation indicatorIf no indication is displayed after press ON/OFF button,reload the batteries.Remote Controller OperationWhen in use, direct signal transmissionhead to the receiver placed on theindoor unitThe distance between the remote controller and the receivershould be max 7m and there should be no obstacle betweenthem.Do not throw the remote controller; prevent it from beingdamaged.17.SLEEP Button(The clock must be corrected before setting sleep function)Used to set sleep mode.18.FAN ButtonUsed to select fan speed:LOW,MID,HIGH,AUTO.19.TIMER OFF DisplayWhen the filter need be cleaned, the sign willappear automatically.25.Code A displayCode A is used for this unit27.Code B display37.HEAT ButtonUsed to select auxiliary heater.Battery loadingBatteries are fitted as follows:Loading the batteryEnsure that batteries are correctly placed in the compartment asrequired for positive and negative terminals.Replacing the battery compartment lidThe battery compartment lid is reinstalled in the reverse sequence.Display reviewPress the button to see if batteries are properly fitted. If no displayappears, refit the batteries.Remove the battery compartment lidSlightly press and disengage the battery compartment lidmarked with ì î and then hold the remote controller by theupper section and then remove the battery compartmentlid by pressing in the direction of the arrow as shown in thefigure above.+ -- +Note:It is recommended that the batteries be removed from thecompartment if the remote controller is not used for anextended period.The remote controller is programmed for automatic test ofoperation mode after the batteries are replaced. When thetest is conducted, all icons will appear on the screen andthen disappear if the batteries are properly fitted.When throw away the waste batteries, please perform inaccordance with the local regulation.Caution:If the remote controller does not operate as designed afterfitting new batteries of the sametype, press the Reset button (marked ) with a pointedarticle.FRESHHIGH/SOTIMERSETFILTERHEALTHRESET LOCKSLEEPMODECLOCKCODE LIGHT321LOW MID HIGHHEAT