Hanseatic HHI6417SM User Manual

Hanseatic HHI6417SM User Manual Manual pdf 46 page image

Page GB-20 Type of fitting– If the hob is installed over an oven withventilation, the clearance between thebase of the appliance and the cover of theoven must be at least 50 mm.– At the front of the hob there must be an airoutlet at least 5 mm in size between thehob and the oven or floor unit.– Veneers, plastic coverings and adhesivesused must be heat-resistant up to 100 °C.LuftauslassLuftauslass– The hob must be positioned in such a waythat the air outlet is not compromised.60 mm56 mm490 mm 560 mm520 mm590 mm>50 mm>50 mm>50 mm>50 mm1. Cut a recess in the worktop: 560 ×490 mm (W × D).If a hob was already installed, the recesscut for it must have the same dimensions.Installing the hob1. Take the hob out of the packaging.2. Remove all protective and packaging ma-terials.3. Turn the hob over and place it upsidedown on a soft, clean surface, for exam-ple the packaging. Otherwise the displaycould be scratched.(12)(13)(12)4. Insert the short, angled end of the twoenclosed retaining clips (12) into the slotsprovided on the underside of the hob.5. Screw down the retaining clips using theenclosed screws (13).6. Place the hob, with the sensor field facingforward, into the worktop recess. Align itevenly and press it firmly into place.Hob Worktop(12)The hob is fastened using the two retainingclips (12).7. Clean the hob thoroughly before its firstuse (see “Cleaning the hob” on pageGB-17).