Hardi New NAVIGATOR 1100 Operator's Manual

Contents

Hardi New NAVIGATOR 1100 Operator's Manual Manual pdf 16 page image

14 HARDI® New NAVIGATOR OPERATOR’S MANUALAdjusting boom transport positionIf the boom wings do not rest accurately in thetrans port brackets, the hydraulic fold cylinders can beadjusted so the wings stop at the right position abovethe transport brackets (Fig 13).Fig. 14The cylinders can be adjusted as described below:1. Lift the boom all the way to the top.2. Fold the boom into transport position. With the foldcylinder pressurized, determine if the boom wingsneed to be adjusted inwards or outwards.3. Relieve the pressure from the fold cylinder byunfolding the boom a few inches.If the boom rests too far in on the transport brackets,loosen the nut (BFig 14) and adjust collar (AFig 14)in towards the cylinder housing.If the boom rests too far out on the transport brackets,the collar (AFig 14) has to go out from the cylinderhousing.4. Secure jam nut (BFig 14).5. Pressurize the cylinder to see if the boom is properlyadjusted. If not, repeat the above procedure until it iscorrectly adjusted.Sprayer SetupTransport bracket settingsThe transport brackets on the New Navigator for theEagle™ SPB and SPC booms are installed at the fac-tory and have no adjustment.The rear transport lock is adjustable, but is set at thefactory according to the boom installed on the sprayer.This should not need adjustment unless a differentboom is installed on the sprayer.WARNING! Always measure the actual totalheight of your sprayer to be sure that there isplenty of clearance at all times while trans-porting the sprayer.Eagle™ Transport bracketFig. 13