Harman Kardon AVR 745 Owner's Manual

Also see for AVR 745: Brochure Brochure Brochure & specs Catalog Brochure

Harman Kardon AVR 745 Owner's Manual Manual pdf 12 page image

12 ZONE II REMOTE CONTROL FUNCTIONSZone II Remote Control FunctionsA Power OffB AVR SelectorC AM/FM Tuner SelectD Input SelectorsE OSD ButtonF Navigation ControlsG Numeric KeysH Disc SkipI Volume Up/DownJ Blank ButtonsK MuteL Clear ButtonM Direct ButtonN Memory ButtonO Tuner Mode ButtonP Transport ControlsQ Set Button The Bridge /DMP SelectorNOTE: The Zone II remote may be used in eitherthe same room where the AVR is located, or itmay be used in a separate room with an option-al infrared sensor that is connected to the AVR’sMulti IR input jack f. When it is used in thesame room as the AVR, it will control the func-tions of the AVR or any compatibleHarman Kardon products in that room. When itis used in a separate room via a sensor connect-ed to the Multi IR Jack f, the buttons forpower, input source, volume and mute will con-trol the source and volume for the second zone,as connected to the Multi Out Jacks •. (Seepage 55 for complete information on using theMultiroom system.)The Zone II remote may be used in either thesame room where the AVR is located, or it maybe used in a separate room with an optionalinfrared sensor that is connected to the AVR’sMulti IR input jack .We strongly recommend that the ZR 10 remotebe used for the initial configuration and setupprocess for the AVR 745.A Power Off: When used in the room wherethe AVR is located, press this button to place theunit in Standby. When it is used in a remoteroom with a sensor that is connected to theMulti IR jack , this button turns the Multi-Room system off.B AVR Selector: Press this button to turn onthe AVR. The input in use when the unit was laston will be selected.C AM/FM Tuner Select: Press this button toselect the Tuner as the input to the Multiroomsystem. Press it again to change between theAM and FM bands.D Input Selectors: When the AVR is off,press one of these buttons to turn the unit onand to select a specific input. When the unit isalready in use, pressing one of these buttons willchange the input.E OSD Button: Press this button to activatethe On Screen Display (OSD) system used to setup or adjust the AVR’s parameters.F Navigation Controls: Depending on themenu or function in use, pressing these buttonswill navigate through menus, scroll throughoption lists or configuration choices, or move thecursor position. Press the left, right, up or downbutton, as appropriate to the adjustment beingmade.KONMLQJDPJGHIFJCBEA29510_AVR745_Engelsk 30/10/06 9:31 Side 12