21INITIAL SETUPStep One – Turn On the DMC 1000The DMC 1000 has four power states, each designed to minimizeunnecessary power consumption. See page 25.The description of each mode and the DMC 1000’s response to thepower controls is shown in Table A7 in the Appendix.IMPORTANT NOTE: When the HDMI Output is used, turn onthe system components in reverse order, starting with the videodisplay, then any receiver or processor, and finally turn on theDMC 1000.The first time the system is used, turn it on as follows:Switch the Master Power Switch to the line position (I), placing theDMC 1000 in Full-Off power mode. See Figure 14.Figure 14 – Master Power SwitchThe “Start DMC 1000 ” message will appear on the front panel, andthe “Starting . . .” message will appear on screen. Allow the systema few minutes to fully start up.The first time the DMC 1000 is turned on, the End User License Agreement(EULA) will appear. See Figure 15. The unit will not respond to any othercommands until you have scrolled through the entire agreement, andaccepted its terms. A copy of the complete EULA appears in the backof this manual, starting on page 41.Figure 15 – End User AgreementAfter you have accepted the EULA, the Main Menu will bedisplayed. See Figure 16.Figure 16 – Main MenuThe Main Menu is the usual starting point for each listeningor viewing session.Step Two – Display the Setup MenuThe first time the system is used, the Setup Menu should be configured.After Initial Setup is completed, unless the user’s requirements change,it is usually not necessary to revisit the Setup Menu. Press the SetupButton (see Figure 17) to display the Setup Menu (see Figure 18).Figure 17 – Setup ButtonFigure 18 – Media Library Setup MenuThe Setup Menu, as with all menus on the DMC 1000, is navigatedusing the F/G/D/E Navigation Buttons. Press the Enter Button to selectan item highlighted on screen.There are six Setup Menus: Media Library, DVD Player, Audio, Video,General and Advanced.Step Three – Media Library SetupThe Media Library Setup Menu determines what action the DMC 1000takes when an audio disc is loaded. Any time an audio CD is loaded, it isautomatically copied at high speed to the Media Library. The DMC 1000does not play audio CDs directly from the disc; playback is from theMedia Library. See Figure 18.Audio Disc Insert Preferences: Select Record Only to copy the disc tothe Media Library without playing it, or Play and Record to begin playbackfrom the Media Library after recording commences.Audio Encoding Quality: Select the format to be used for recordingaudio CDs to the Media Library.• Basic (MP3: 128kb/sec)• Medium (MP3: 192kb/sec)• High (MP3: 256kb/sec)• Best (MP3: 320kb/sec)• Lossless (.wav)