Chapter 2 Quick Start Switching On© 2012 Harmonic Inc. 20 ProView 7000 v.2.6, Rev. E2.1.3 Cable ConnectionsConnect the remaining cables:■ DVB-S/S2■ ASI■ LAN■ Video output■ Video monitor2.2 Switching OnSwitch the unit on with the rear power switch.Once the boot process is completed (after 2-3 minutes) the Status OK message displays onthe front panel LCD.2.3 Configuring the IP ParametersTo configure the IP parameters of a ProView 7000™:1. Press on the keypad.The root menu displays.2. Navigate Unit > Management Port > IP Configuration.3. Set the IP Address, Subnet Mask and Default Gateway for the port.4. After any change in the IP configuration, the Apply port changes item is added to the IPConfiguration sub-menu to allow confirmation of the port setup.5. Select Apply port changes.6. Select Apply Changes.Status OKNo Service SelectedNo Service SelectedIP Configuration1 IP Address 127.000.000.0102 Subnet Mask 255.255.255.0003 Default Gateway 000.000.000.000
