Chapter 5 Front Panel Interface Front Panel Root Menu© 2011 Harmonic Inc. 169 ProView 7000 v.2.4, Rev. A· UDP Port – The range is 0 – 65535. The default is 1000.• Socket De-Jittering Mode – The default is Normal. The options are:· Low – Low Delay· Normal – Network jitter less than 50 msec.· High – Network jitter less than 300 msec.• Socket De-Jittering Status – Status display only.• SSM – Options:· Enable – You can configure one source IP address. Only packets with this sourceaddress are processed.· Disable – The device accepts all packets with destination IPs and ports that matchthe socket regardless of their source IP.Routing Table – Use the Routing Table menu to manage up to five routing destinations forGbE mode In when the IP address is on a different network. The Routing Table menucomprises 5 Entry sub-menus.In each Entry sub-menu you can configure the following:❑ Destination Type – The options are:• Network• Host❑ IP Address❑ Subnet Mask❑ Default Gateway – The Default Gateway must be the same as the device managementport address.❑ Interface – The options are:• GbE 1• GbE 25.2.5 Alarms Table MenuThe Alarm Monitoring screen displays a list of all active alarm messages raised by theProView 7000 device.To display the alarm list screen:❖ Navigate Root > Alarms Table.Severity Alarm Time1 Major Link down 22:582 Critical Voltage Error
