Appendix E Software Management Software Upgrade Manager© 2011 Harmonic Inc. 193 ProView 7000 v.2.4, Rev. AE.2.1 Upgrading the Firmware of ProView 7000sIt is recommended to upgrade all ProView 7000s at the same time. A device must beconnected to be able to upgrade it, see 4.3.3.2 Connecting a Device. Once the device upgradeis successfully completed, the devices reboot and EMS closes. It takes several minutes toupgrade a device. The new version loads into the inactive firmware slot and does not replacethe active version.To upgrade the firmware of several ProView 7000s:1. Select Tools > Firmware Software Upgrade Manager.The Software Upgrade Manager dialog displays.2. Mark the Upgrade checkboxes of the devices that you want to upgrade.—or—To upgrade many devices:a Click Remove to remove device names that are not part of the upgrade.b Click Select All to select all devices in the list.3. Open the Upgrade File browser and browse to the zip file containing the new software onyour local hard disk.4. Click Select.5. Click Start Upgrade.To upgrade your EMS installation to the same version of the managed devices:1. Run a web browser and enter a ProView 7000 IP address.The initial ProView 7000 dialog displays.2. Click Launch ProView 7000 EMS on the ProView 7000 web page to install the EMS.The EMS application installs.E.2.2 Viewing the Software Upgrade LogTo view the software upgrade log:1. Select Tools > Firmware Software Upgrade Manager.The Software Upgrade Manager dialog displays.2. Click Log.The Activity Log dialog displays.
