v Connect and disconnect cables as described in the following table wheninstalling, moving, or opening covers on this product or attached devices.To Connect To Disconnect1. Turn everything OFF.2. First, attach all cables to devices.3. Attach signal cables to connectors.4. Attach power cords to outlet.5. Turn device ON.1. Turn everything OFF.2. First, remove power cords from outlet.3. Remove signal cables from connectors.4. Remove all cables from devices.v Statement 2CAUTION:When replacing the lithium battery, use only IBM Part Number 33F8354 or anequivalent type battery recommended by the manufacturer. If your system has amodule containing a lithium battery, replace it only with the same module typemade by the same manufacturer. The battery contains lithium and can explode ifnot properly used, handled, or disposed of.Do not:v Throw or immerse into waterv Heat to more than 100°C (212°F)v Repair or disassembleDispose of the battery as required by local ordinances or regulations.v Statement 3CAUTION:When laser products (such as CD-ROMs, DVD-ROM drives, fiber optic devices,or transmitters) are installed, note the following:v Do not remove the covers. Removing the covers of the laser product couldresult in exposure to hazardous laser radiation. There are no serviceable partsinside the device.v Use of controls or adjustments or performance of procedures other than thosespecified herein might result in hazardous radiation exposure.DANGER: Some laser products contain an embedded Class 3A or Class 3B laserdiode. Note the following:Laser radiation when open. Do not stare into the beam, do not viewdirectly with optical instruments, and avoid direct exposure to thebeam.v Statement 4212 Hardware Maintenance Manual
