IBM 71412RU User Manual

Also see for 71412RU: Brochure & specs

Contents

Select this choice enable or disable the execute disable bit feature. Enableis the default value.- Intel Virtualization TechnologySelect this choice to enable or disable the Intel virtualization technology.Select Enable to make available the additional hardware capabilities ofvirtual machine extensions. Enable is the default value.- Processor IP PrefetcherSelect this choice to enable or disable the IP prefetcher. Enable is thedefault value.- Processor DCU PrefetcherSelect this choice to enable or disable the DCU prefetcher. Enable is thedefault value.- C1ESelect this choice to enable or disable the C1E feature. The C1E featurereduces microprocessor power consumption. Enable is the default value.– TPM MenuSelect this choice to set the trusted platform module (TPM) feature. For moreinformation, see http://www.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=MIGR-5072502&brandind=5000008.– Partition Chassis OptionsSelect this choice to set the partition configuration options for use in amulti-node configuration.– Advanced PCI SettingsSelect this choice to view and set the end-to-end cyclic redundancy check(ECRC) of individual PCI Express slots. ECRC is a data transmission errordetection feature. You can also enable or disable the ROM execution ofindividual PCI Express slots.– PCI Slot/Device InformationSelect this choice to view system resources that are used by installed PCIExpress devices. PCI Express devices are usually configured automatically.This information is saved when you exit. The Save Settings, RestoreSettings, and Load Default Settings choices on the Configuration/SetupUtility main menu do not save the PCI Slot/Device Information settings.– RSA II SettingsSelect this choice to view and change Remote Supervisor Adapter II settings.Select Save Values and Reboot RSA II to save the changes that you havemade in the settings and restart the Remote Supervisor Adapter II.- RSA II MAC AddressThis is a nonselectable menu item that displays the Remote SupervisorAdapter II MAC address.- DHCP IP AddressThis is a nonselectable menu item that displays the Remote SupervisorAdapter II DHCP IP address, if DHCP is enabled.- DHCP ControlSelect this choice to set the DHCP control. DHCP Enabled is the default. Ifyou select Use Static IP, use Static IP Address to set the address.- Static IP AddressSelect this choice to set the static IP address for the Remote SupervisorAdapter II.Chapter 3. Configuring the server 63