IBM 7985 Problem Determination And Service Manual

3. Rotate the free end of the adapter down under the tabs and onto the pins onthe retainer brackets; then, press the adapter into the connector on the risercard and make sure that all the tabs on the latch brackets secure the adapter inplace.4. Replace the riser-card assembly (see “Installing the riser-card assembly” onpage 155)5. Install the cover (see “Installing the cover” on page 110).6. Slide the server into the rack.7. Connect the cables and power cords.8. Turn on all attached devices and the server.9. Restore the backup copy of the configuration to the Remote Supervisor AdapterII SlimLine. If you do not have a backup copy of the configuration, see thedocumentation that comes with the Remote Supervisor Adapter II SlimLine forinformation about installing the firmware and configuring the options.Note: When you start the server for the first time after you install a RemoteSupervisor Adapter II SlimLine, the start-up process will take several minutes longerthan a typical start-up.Removing the ServeRAID SAS controllerAttention: To avoid breaking the retaining clips or damaging the connectors,handle the clips gently.Note: The following illustration shows removing a ServeRAID-8k SAS controller;the ServeRAID-8k-l SAS controller does not have a battery.BatteryRAID controllerBattery mountingclipsBattery mountingtabsBattery cableBattery cableconnectorTo remove the ServeRAID SAS controller, complete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 105.120 IBM System x3655 Type 7985 and 7943: Problem Determination and Service Guide