IBM 7985 Problem Determination And Service Manual

the regular keyboard test to test a USB keyboard, and you can use the regularmouse test to test a USB mouse. You can run the USB interface test only if no USBdevices are attached. The USB test will not run if a Remote Supervisor Adapter IISlimLine is installed.To view server configuration information (such as system configuration, memorycontents, interrupt request (IRQ) use, direct memory access (DMA) use, devicedrivers, and so on), select Hardware Info from the top of the screen.Diagnostic text messagesDiagnostic text messages are displayed while the tests are running. A diagnostictext message contains one of the following results:Passed: The test was completed without any errors.Failed: The test detected an error.User Aborted: You stopped the test before it was completed.Not Applicable: You attempted to test a device that is not present in the server.Aborted: The test could not proceed because of the server configuration.Warning: The test could not be run. There was no failure of the hardware that wasbeing tested, but there might be a hardware failure elsewhere, or another problemprevented the test from running; for example, there might be a configurationproblem, or the hardware might be missing or is not being recognized.The result is followed by an error code or other additional information about theerror.Viewing the test logTo view the test log when the tests are completed, select Utility from the top of thescreen and then select View Test Log. The test-log data is maintained only whileyou are running the diagnostic programs. When you exit from the diagnosticprograms, the test log is cleared.To save the test log to a file on a diskette, a USB key, or to the hard disk, clickSave Log on the diagnostic programs screen and specify a location and name forthe saved log file.Notes:1. To create and use a diskette, you must add an optional external diskette drive tothe server before initiating the diagnostic programs.2. To save the test log to a diskette, you must use a diskette that you haveformatted yourself; this function does not work with preformatted diskettes. If thediskette has sufficient space for the test log, the diskette can contain other data.3. To save the test log to a USB key, the key must be plugged in when the serveris booted (hot swap is not supported in DOS).Diagnostic error codesThe following table describes the error codes that the diagnostic programs mightgenerate and suggested actions to correct the detected problems.56 IBM System x3655 Type 7985 and 7943: Problem Determination and Service Guide