Contents - Table Of Contents
- Table Of Contents
- Chapter 1. About this manual
- Chapter 2. General Checkout
- Chapter 3. General information
- Types 8303, 8304, and 8312
- Types 8305, 8306, 8309, and 8313
- Types 8307, 8308, 8310, 8311, 8314, and 8315
- Physical specifications
- Types 8303, 8304 and 8312
- Available options
- Chapter 4. Diagnostics
- Setup Utility program
- Product Recovery Program menu
- Diagnostics
- Test results
- Quick and Full erase - hard drive
- Viewing the test log
- Chapter 5. Installing Options
- Locating the connectors on the rear
- Obtaining device drivers
- Removing the cover
- Locating components
- Identifying parts on the system board
- Installing memory
- Installing adapters
- Installing internal drives
- Installing a rope clip
- Changing the battery
- Chapter 6. FRU Removals
- Replacing a microprocessor
- Hard disk drive removal
- Power supply removal
- System board removal
- Replacing the cover, Types 8301 and 8302
- Chapter 7. Symptom-to-FRU Index
- Diagnostic error codes
- Beep symptoms
- No-beep symptoms
- POST error codes
- Miscellaneous error messages
- Undetermined problems
- Chapter 8. Parts listing
- Chapter 9. Additional Service Information
- Vital product data
- Alert on LAN
- Flash from Operating System (WinPhlash)
- Flash recovery boot block jumper
- Power management
- Automatic Power-On features
- information
- Electrical safety
- Safety inspection guide
- Handling electrostatic discharge-sensitive devices
- Grounding requirements
- Send us your comments
- Problem determination tips
- Trademarks
|
Miscellaneous error messagesMessage/Symptom FRU/ActionCMOS Backup Battery inaccurate 1. CMOS Backup Battery (see “Safetyinformation” on page 271)2. System BoardChanging colors 1. DisplayComputer will not power-off. See “PowerSupply Errors” on page 87. 1. Power Switch2. System Board3. Riser cardComputer will not RPL from server 1. Ensure that network is in startupsequence as first device or first deviceafter diskette2. Ensure that network adapter is enabledfor RPL3. Network adapter (Advise networkadministrator of new MAC address)Computer will not Wake On LAN (ifapplicable) 1. Check power supply and signal cableconnections to network adapter2. Ensure that the operating system settingsare set to enable Wake on LAN3. Ensure Wake On LAN feature is enabledin Setup/Configuration (see “SetupUtility program” on page 24)4. Ensure network administrator is usingcorrect MAC address5. Ensure no interrupt or I/O addressconflicts6. Network adapter (advise networkadministrator of new MAC address)Dead computer. See “Power Supply Errors”on page 87. 1. Power Supply2. System Board3. Riser cardDiskette drive in-use light remains on ordoes not light when drive is active. 1. Diskette Drive2. System Board3. Diskette Drive Cable4. Riser cardFlashing cursor with an otherwise blankdisplay. 1. System Board2. Primary Hard Disk Drive3. Hard Disk Drive Cable4. Riser cardIncorrect memory size during POST 1. Run the Memory tests2. Memory Module3. System BoardChapter 7. Symptom-to-FRU Index 125 PreviousNext |