IBM Aptiva 2174 Hardware Maintenance Service

General Information 5Power Management• ACPI 1.0/PC99/OnNow compliant motherboard and BIOS.• SMM, VESA monitor specification compliant.• APM 1.2 support with password restart option.• Software shutdown by Windows 98.• Power-on Switch must support Soft-Off and Full-Off.- Touch for 1 second or less to put system on Suspend state.- Touch and hold for 4 seconds to put system on Full-Off state (PowerSupply 5V standby remained).• System enters standby mode if any of following conditions are met:- Execute standby from Windows 98 Start menu- Press system power button if it sets to act as standby function- System is idle and the standby timer set in the Windows 98 PowerManagement Property elapsesPower Supply• PC-98 compatible 200W ATX power supply• Searchable high/low voltage selectionInternal Cabling• Two 40-pin ribbon cables for hard disk drives and CD/DVD-ROM drive.• One 34-pin ribbon cable for AT diskette drive.• One 4-pin (2-wire) cable for hard disk drive light-emitting diode (LED).• One 3-pin (3-wire) cable for power light-emitting diode (LED).• One 2-pin (2-wire) cable for power switch.• One 4-pin modem voice-in/speaker-out cable.• 56.6 Kbps PCI modem adapter card with data/fax/voice or non-voicefeatures.Monitor (Not included with some models)• Super Video Graphics Array (SVGA) monitor.• VESA power saving mode compliant.• Connector for a detachable grounded 3-wire power cord• 1.8-m (5.8-ft.) signal cable attached• Auto-sensing power input for 100 Vac to 240 Vac