asu set SYSTEM_PROD_DATA.SYsInfoProdName m/t_model --userimm_user_id--password imm_passwordasu set SYSTEM_PROD_DATA.SYsInfoSerialNum s/n--user imm_user_id--password imm_passwordasu set SYSTEM_PROD_DATA.SYsEncloseAssetTag asset_tag --userimm_user_id--password imm_passwordExamples that do use the user ID and password default values:asu setSYSTEM_PROD_DATA.SysInfoProdName m/t_model asu setSYSTEM_PROD_DATA.SysInfoSerialNum s/n asu setSYSTEM_PROD_DATA.SysEncloseAssetTag asset_tagv Online KCS access (unauthenticated and user restricted):You do not need to specify a value for access_method when you use thisaccess method.The KCS access method uses the IPMI/KCS interface. This method requiresthat the IPMI driver is installed. Some operating systems have the IPMIdriver installed by default. ASU provides the corresponding mapping layer.See the Advanced Settings Utility Users Guide for more details. You can accessthe ASU Users Guide from http://www.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=TOOL-ASU&brandind=5000016.The following commands are examples of using the user ID and passworddefault values and not using the default values:Examples that do not use the user ID and password default values:asu set SYSTEM_PROD_DATA.SYsInfoProdName m/t_modelasu set SYSTEM_PROD_DATA.SYsInfoSerialNum s/nasu set SYSTEM_PROD_DATA.SYsEncloseAssetTag asset_tagv Remote LAN access. Use the following syntax:Note: When using the remote LAN access method to access IMM using theLAN from a client, the host and the imm_external_ip address are requiredparameters.host imm_external_ip [user imm_user_id][password imm_password]imm_external_ipThe external IMM LAN IP address. There is no default value. Thisparameter is required.imm_user_idThe IMM account (1 of 12 accounts). The default value is USERID.imm_passwordThe IMM account password (1 of 12 accounts). The default value isPASSW0RD (with a zero, not the letter O).The following commands are examples of using the user ID and passworddefault values and not using the default values:Examples that do not use the user ID and password default values:asu set SYSTEM_PROD_DATA.SYsInfoProdName m/t_model--host imm_ip --userimm_user_id --password imm_passwordasu set SYSTEM_PROD_DATA.SYsInfoSerialNum s/n --host imm_ip --userimm_user_id--password imm_passwordasu set SYSTEM_PROD_DATA.SYsEncloseAssetTag asset_tag--host imm_ip--user imm_user_id --password imm_passwordExamples that do use the user ID and password default values:Chapter 4. Configuring the blade server 81
