Check Procedures 39Incorrect memory sizeshown or repeated duringPOST.1. Insert the memorymodules in the RIMMsockets properly, thenreboot the system.2. Memory module. See“005 -” on page 59 toreplace memorymodule.3. System board.System works but fails toenter power saving modewhen the PowerManagement Mode is set to[Enabled], and powersaving timer set in BIOS haselapsed.1. Enter Configuration/Setup Utility and loaddefault settings.2. In Windows ME orWindows 2K, checksettings in PowerManagement Propertyof Control Panel.3. Reload software fromRecovery CD.System hangs beforesystem boot.1. See “Index ofSymptoms, Messages,Error Codes, or Beeps”on page 32.2. See “UndeterminedProblems” on page 68System hangs after systemboot.1. Execute a system test(“Diagnostics / AllTests” in PC-Doctordiagnostics program)and set it to stop at“Halt on Error” to seethe potential cause ofthe problem.2. “UndeterminedProblems” on page 68.Blinking cursor only; systemdoes not work.1. See “Start” on page 27.2. Diskette/IDE driveconnection/cables3. Diskette/IDE diskdrives4. See “UndeterminedProblems” on page 685. System boardError Symptoms Action/FRU
